海兔燒寫錯誤信息:
Bootrom start
Boot Media: NAND
##############################################
Decrypt auxiliary code ...OK

lsadc voltage min: 000002FB, max: 00000306, aver: 000002FF, index: 00000001

Failed to send the boot data.
1. The system fails to run properly due to an error in boot code compilation.
2. If the secure boot function is disabled and boot rootkey is set for the OEM, the boot image is encrypted, but the boot rootkey used for encrypting the boot is different from the boot rootkey burnt to the OTP.
Timeout error.
3. The chip OTP is set to forcibly decrypt the boot image. However, the boot is not correctly encrypted.
4. The board DDR is faulty.
5. The boot code does not support the type of the flash memory to be burnt. If the boot print function is enabled, you can view the printing information through the serial port, showing that the current flash memory type is not supported.
Failed to send the head frame.

Enter boot auxiliary code

Auxiliary code - v1.00
DDR code - V1.1.2.1 20171011
Build: Sep 11 2018 - 19:55:16

Reg Version:  v1.5.2`
Reg Time:     2018/10/10 16:14:27
Reg Name:     hi3798m3hdms1_hi3798mv300h_DDR3-1866_1GB_16bitx2_2layers_cm.re5
請檢查當前programmer或boot是否與單板匹配。
Failed to download fastboot!

如果是刷錯了eMMC固件的我沒的招。
因為海兔無法燒寫

用強刷包短接閃存5.6腳試試

hongy 發(fā)表于 2021-3-10 00:21
給你燒錄包也不見得你會用，nand比較難搞

關鍵是沒有，有的話倒是可以學習下。

給你燒錄包也不見得你會用，nand比較難搞

陳長兵 發(fā)表于 2021-3-9 18:21
引導沒了

這款盒子很奇怪，找了N多固件都沒有用。

引導沒了

xiaolu8521855 發(fā)表于 2021-3-9 10:49
可以救用海思燒錄

問題是沒有救磚包或原廠備份。

跪求廣電U點盒E900-S(3798mv310)原廠備份